A. Amin, A. Lion, S. Sekita, and Y. Okui, Nonlinear dependence of viscosity in modeling the rate-dependent response of natural and high damping rubbers in compression and shear: Experimental identification and numerical verification, Int. J. Plast, vol.22, pp.1610-1657, 2006.

E. Arruda and M. Boyce, A three-dimensional model for the large stretch behavior of rubber elastic materials, J. Mech. Phys. Solids, vol.41, issue.2, pp.389-412, 1993.
URL : https://hal.archives-ouvertes.fr/hal-01390807

A. Azoug, Micromécanismes et comportement macroscopique d'un élastomère fortement chargement, Ecole Polytechnique, 2010.

A. Azoug, A. Constantinescu, R. Pradeilles-duval, M. F. Vallat, R. Neviere et al., Effect of the sol fraction and hydrostatic deformation on the viscoelastic behavior of pre-strained highly filled elastomers, J. Appl. Polym. Sci, vol.127, pp.1772-1780, 2013.

A. Azoug, A. Thorin, R. Neviere, R. Pradeilles-duval, and A. Constantinescu, Influence of orthogonal prestrain on the viscoelastic behaviour of highly-filled elastomers, Polym. Test, vol.32, pp.375-384, 2013.
URL : https://hal.archives-ouvertes.fr/hal-01402496

A. Azoug, A. Constantinescu, R. M. Paridelles-duval, and R. Neviere, Influence of cross-linking and plasticizing on the viscoelasticity of highly-filled elastomers, J. Appl. Polym. Sci, vol.131, pp.201-215, 2014.

A. Azoug, A. Constantinescu, R. M. Paridelles-duval, and R. Neviere, Influence of fillers and bonding agents on the viscoelasticity of highly-filled elastomers, J. Appl. Polym. Sci, vol.131, pp.321-325, 2014.
URL : https://hal.archives-ouvertes.fr/hal-01219758

A. Azoug, A. Constantinescu, and R. Neviere, Molecular origin of the influence of the temperature on the loss factor of a solid propellant, Propellants, Explosives, 2014.
URL : https://hal.archives-ouvertes.fr/hal-01219725

A. Azoug, A. Constantinescu, R. Neviere, and G. Jacob, Microstructure and deformation mechanisms of a solid propellant using 1H NMR spectroscopy, Fuel, vol.147, pp.1-9, 2015.
URL : https://hal.archives-ouvertes.fr/hal-01219721

M. Baumgaertel and H. Winter, Interrelation between continuous and discrete relaxation time spectra, J. Non-Newton. Fluid Mech, vol.44, pp.15-36, 1992.

E. Botelho, L. Figiel, M. Rezende, and B. Lauke, Mechanical behavior of carbon fiber reinforced polyamide composites, Compos. Sci. Technol, vol.63, pp.1843-1855, 2003.

H. Brinson, Polymer Engineering Science and Viscoelasticity. An Introduction, 2008.

R. Christensen, A nonlinear theory of viscoelasticity for application to elastomers, J. Appl. Mech, vol.47, pp.762-768, 1980.

B. Coleman and M. Gurtin, Thermodynamics with internal state variables, J. Chem. Phys, vol.47, pp.597-613, 1967.

M. Doi, Molecular theory of the viscoelastic properties of concentrated polymer solutions, Chem. Phys. Lett, vol.26, pp.269-275, 1974.

W. Findley, J. Lai, and K. Onaran, Creep and Relaxation of Nonlinear Viscoelastic Materials, 1976.

B. Halphen and Q. Nguyen, Sur les matériaux standards généralisés, J. Méc, vol.14, pp.39-63, 1975.

G. A. Holzapfel, Non Linear Solid Mechanics: A Continuum Approach for Engineering, 2006.

N. Huber and C. Tsakmakis, Finite deformation viscoelasticity laws, Mech. Mater, vol.32, pp.1-18, 2000.

D. Jalocha, A. Constantinescu, and R. Neviere, Revisiting the identification of generalized maxwell models from experimental results, Int. J. Solids Struct, 2015.
URL : https://hal.archives-ouvertes.fr/hal-01219740

D. Jalocha, A. Constantinescu, and R. Neviere, Prestrained biaxial DMA investigation of viscoelastic nonlinearities in highly filled elastomers, Polym. Test, vol.42, pp.37-44, 2015.
URL : https://hal.archives-ouvertes.fr/hal-01219730

W. Knauss, L. Emri, and H. Lu, Handbook of Experimental Solid Mechanics, 2006.

D. Kurtz, J. Kurweil, and C. Swartz, Theory of Integration, 2004.

P. Letallec and C. Rahier, Numerical models of steady rolling for non linear viscoelastic structures in finite deformations, Int. J. Numer. Methods Eng, vol.37, pp.1159-1186, 1994.

A. Lion and C. Kardelky, The Payne effect in finite viscoelasticity: Constitutive modelling based on fractional derivatives and intrinsic time scales, Int. J. Plast, vol.20, pp.1313-1345, 2004.

V. Litvinov and P. Steeman, EPDM-carbon black interactions and the reinforcement mechanisms, as studied by low-resolution 1H NMR, Macromolecules, vol.32, pp.8476-8490, 1999.

O. Lopez-pamies, A new I1-based hyperelastic model for rubber elastic materials, C. R., Méc, vol.338, pp.3-11, 2010.

H. Markovitz, Boltzmann and the beginnings of rheology, Trans. Soc. Rheol, vol.21, issue.3, pp.381-398, 1977.

D. Mowery, R. Assink, and M. Celina, Sensitivity of proton NMR relaxation times in a HTPB based polyurethane elastomer to thermo-oxidative aging, Polymer, vol.46, pp.10919-10924, 2005.

L. Mullins, Softening of rubber by deformation, Rubber Chem. Technol, vol.42, issue.1, pp.339-362, 1969.

S. Ozupek, Constitutive Modeling of Hight Elongation Solid Propellants, 1989.

S. Ozupek and E. Becker, Constitutive modeling of high-elongation solid propellants, J. Eng. Mater. Technol.-Trans. ASME, vol.114, pp.111-115, 1992.

A. Payne, The dynamic properties of carbon black-loaded natural rubber vulcanizates. Part I, J. Appl. Polym. Sci, vol.6, pp.53-57, 1962.

C. Roeder and J. Stanton, Elastomeric bearing: State of the art, J. Struct. Eng, vol.109, pp.2853-2871, 1983.

M. Simhambhatla and A. Leonov, On the rheological modeling of filled polymers with particle matrix interactions, Rheol. Acta, vol.34, pp.329-338, 1995.

J. Simo, On a fully three-dimensional finite-strain viscoelastic damage model: Formulation and computational aspects, Comput. Methods Appl. Mech. Eng, vol.60, pp.153-173, 1987.

J. Simo, T. J. Hughes, and T. Smith, Empirical equations for representing viscoelastic functions and for deriving spectra, Computational Inelasticity. Interdisciplinary Applied Mathematics, vol.35, pp.39-50, 1971.

P. Steinmann, M. Hossain, and G. Possart, Hyperelastic models for rubber-like materials: Consistent tangent operators and suitability for Treloar's data, Arch. Appl. Mech, vol.82, pp.1183-1217, 2012.

S. Swanson and L. Christensent, A constitutive formulation for high elongation propellants, J. Spacecr, vol.20, pp.559-566, 1983.

A. Thorin, A. Azoug, and A. Constantinescu, Influence of prestrain on mechanical properties of highly-filled elastomers: Measurements and modeling, Polym. Test, vol.31, pp.978-986, 2012.
URL : https://hal.archives-ouvertes.fr/hal-00723704

D. Widder, The Laplace Transform, 1946.

M. Williams, R. Landel, and J. Ferry, The temperature dependence of relaxation mechanisms in amorphous polymers and other glass-forming liquids, J. Am. Chem. Soc, vol.77, pp.3701-3707, 1955.

F. Xu, N. Aravas, and P. Sofronis, Constitutive modeling of solid propellant materials with evolving microstructural damage, J. Mech. Phys. Solids, vol.56, pp.2050-2073, 2008.

B. Zimm and O. Lumpkin, Reptation of a polymer chain in an irregular matrix: Diffusion and electrophoresis, Macromolecules, vol.26, pp.226-234, 1993.